Booster Pump Service Manual & Troubleshooting Guide
Table of Contents
IV. REASSEMBLY OF THE SYSTEM PUMP

Bell & Gossett Booster Pumps operate best when accurately aligned and securely affixed to the system. Noise, vibration, and efficiency are operational parameters that may be adversely affected by the reassembly of the pump. It is therefore very important that the following steps be carefully followed to ensure dependable performance.

1. Inspect and Clean the pump Body
Inspect and Clean the pump Body

The pump body must be cleaned. Excess debris from water scale, worn gaskets or any other material found in the pump body must be removed. A screwdriver may be used to scrape any material stuck to the body.

The seating surface of the new gasket must be free of all foreign material to insure proper seating and leak prevention.

Previous Page Next Page